MTN Electronics, 17mm, 3V, 10+ Amp Capable High Power LED Flashlight Driver

Description

New in package
- MTN Electronics, 17mm,
3V
, 10+ Amp capable LED flashlight driver - Direct Drive -
Comes with driver, driver spring and 22g silicone jacketed wire
, unopened in original packaging, wire ends are pre-tinned and ready for solder.
One of the most powerful LED drivers on the market today
, capable of both very low and very high output, running single or multiple cells, and
tested by Adventure Sports at over 125 watts
of output!! - With a capable battery, or batteries and proper heat syncing
I had considered installing this in a 21700 cell light using a 22mm to 17mm driver adapter and then running a single SBT90.2 LED, but ended up picking up hoped up 3X21D instead. With this driver, your battery is the limit, this could build a monster light with the proper battery(s) and heat syncing.
Driver details:
- 17mm
- Capable of over 10 amps of power delivery \ direct drive (limited only by your battery selection)
- User electable mode groups 3-16V configurable
- Single or Multi LED capable
User Interface (UI):
- Dr.Jones Guppy2
Guppydrv Instructions:
- To switch mode groups: rapidly tap the switch 8 times, the light will then enter the programming mode and begin to flash. With the light in programming mode, tap the switch the same number of times as your desired mode group. The light will blink and your mode group will be memorized.
- Example: To select mode group 3, tap the switch 8 times quickly to enter programming mode. As soon as the light enters programming mode and beings flashing, tap the switch three times. The light will blink to recognize the mode group change.
- To set the turbo timer: rapidly tap the switch 8 times, the light will then enter the programming mode and begin to flash. With the light in programming mode, tap the switch 30 times to enter the turbo timer set mode. The light will then switch to 100% power. When the light is at the desired temperature for the turbo step down, turn the light off. The turbo timer will then be set. The turbo timer steps the light down to 50% regardless of the mode group set.
- To disable the turbo timer simply go into program and cut it off in >3 seconds.
User Selectable Groups:
1% - 25% - 100% | Memory
1% - 25% - 100% | No Memory
100% - 25% - 1% | No Memory
1% - 25% - 100% - Strobe | No Memory
1% - 25% - 100% - Strobe | Memory
10% - 100% | Memory
10% - 100% | No Memory
100% - 10% | No Memory
100%
100% - Strobe | No Memory
Strobe - 100% | No Memory
ML - 2% - 25% - 100% | Memory
ML - 2% - 25% - 100% - Strobe - Beacon | No Memory
ML - 100% | No Memory
100% - ML | No Memory
ML - 100% | Memory
ML - 1% - 5% - 15% - 40% - 100% | Memory
ML - 1% - 5% - 15% - 40% - 100% | No Memory
100% - 40% - 15% - 5% - 1% - ML | No Memory
100% - 40% - 15% - 5% - 1% - ML | Memory
1% - 5% - 15% - 40% - 100% | Memory
1% - 5% - 15% - 40% - 100% | No Memory
100% - 40% - 15% - 5% - 1% | No Memory
100% - 40% - 15% - 5% - 1% | Memory