High Power 2200mW Deep UV 270NM SMD LED 5x5 Array with Tall Lens and Heat Sink

Description

Feature:
Eliminates reflow soldering
Plug-n-play with AWG 23 or 24 wire
Optional heat sink attachment and power connection
Optional quartz protector
Specification:
Size:                                                   92.1 x 92.1 mm
Driving current:                                   1.75A
Peak wavelength:                               270 +/-15nm
Radiant Flux:                                      2200 mW (+/-10%)
Forward voltage (LED & driver):        33V (+/-7V)
Spectrum Half Width:                        11nm
View Angle:                                        150° (low lens) / 35° (tall lens)
Note:
1.
Forced liquid cooling is required when input wattage is at 100W or higher
2.
>100 Watt-rated heat-pipe units typically found for CPU/GPU cooling is recommended
3.
High quality thermal grease should be used when mounting the PCB to heat sink
4.
Regulated 36-40V, 3A DC power is recommended
5.   Volume discount available
6.
Delivery time can be sooner depending on volume
Warning:
UVC LEDs emit deep ultraviolet radiation, with extremely high intensity near its surface. This allows rapid disinfection but safety precautions must be observed during assembly and testing.
By purchasing the UVC chips (bare dice) or packaged LEDs from the manufacturer, the customer hereby agrees to absolve the manufacturer and seller's responsibility of any bodily harm as a result of failure to observe the precautions, warnings and guidelines.
All assembly workers, operators and bystanders must wear eye and skin protection when the UVC LEDs are energized.  Bare-eye observation (including through microscopes) and bare-hand handling of a UVC LED in operation is PROHIBITED.
UVC light can be easily absorbed, so any oil or other absorbent liquid or solid substance must NOT be allowed to touch the sapphire side of the UVC chip, or the dome lens on a packaged LED.
Do not apply pressure to the dome lens on packaged LED.